- This topic is empty.
-
Posts
-
Have made the washers for the rear footpegs in stainless steel 1,5mm.
Incase anyone need them,for clubmembers they are 9,= euro for one set left and right, included shipping worldwide.
.Regards,
WimWim, I’ll get my act together and paypal you for a set or two of these little suckers. Pretty sure they are the same as the CBX, coz it needs a set as well. I was putting the rear pegs back together a few weeks back and these guys gave me a bit of grief. By the way, I have put the new main footpeg rubbers on last weekend, looking good so far.
Hi Brian,oke thanks.Yes on the CBX are they also, the pegs are the same.Mostly the hole where the little ball falls is worn.
Have very good results with the sika 552,they are very tight!What have you used for glue?
Regards,
WimI had already bought the original sika you recommended before I saw your post on the 552 product. No problem, they look and feel tight, I’ll give them a bit of a strength test later.
The price for two sets of these footpeg plates to Australia -18?Yes Brian 18,= euro total.The sika 552 is what they say primerless,but test it the other type should do also,preperation is the important thing to be done.
Thank you Brian,Best regards,
Wim
Hi Wim
I would like 2 sets of these Footpeg washers please and have just sent 18 euro’s to your Paypal account. I don’t know how long it will take to produce the washers but you may be able to give them to Andre as I will meet him at Stafford 19th-21st October.
Thanks
Trev
Hi Trev,have them ready,will send them to your adress.
Thanks,Wim
- You must be logged in to reply to this topic.